摘要 :
Development of streamwise counter-rotating vortices induced by leading edge patterns with different pattern shape is investigated using hot-wire anemometry in the boundary layer of a flat plate. A triangular, sinusoidal and notche...
展开
Development of streamwise counter-rotating vortices induced by leading edge patterns with different pattern shape is investigated using hot-wire anemometry in the boundary layer of a flat plate. A triangular, sinusoidal and notched patterns with the same pattern wavelength lambda of 15 mm and the same pattern amplitude A of 7.5 mm were examined for free-stream velocity of 3 m/s. The results show a good agreement with earlier studies. The inflection point on the velocity profile downstream of the trough of the patterns at the beginning of the vortex formation indicates that the vortices non-linearly propagate downstream. An additional vortex structure was also observed between the troughs of the notched pattern. (C) 2017 Elsevier Inc. All rights reserved.
收起
摘要 :
Development of counter-rotating streamwise vortices in a rectangular channel with one-sided wavy surface has been experimentally quantified using hot-wire anemometry. The wavy surface has fixed amplitude of 3.75 mm. The counter-ro...
展开
Development of counter-rotating streamwise vortices in a rectangular channel with one-sided wavy surface has been experimentally quantified using hot-wire anemometry. The wavy surface has fixed amplitude of 3.75 mm. The counter-rotating vortices are pre-set by means of a sawtooth pattern cut at the leading edge of the wavy surface. Variations of the central streamwise velocity U-c with a channel gap H = 35 mm and 50 mm (corresponding to a Reynolds number from 1600 to 4400) change the instability of the flow which can be distinguished from the velocity contours at a certain spanwise plane. The streamwise velocity contours and turbulence intensity for Reynolds number Re = 3100 and H = 35 mm show the disappearance of the mushroom-like vortices prior to turbulence near the second peak of the wavy surface, while for higher Re, this phenomenon occurs earlier. Under certain conditions, for example, for Re = 4400 and H = 50 mm, the splitting of the vortices can also be observed. (C) 2015 Elsevier Inc. All rights reserved.
收起
摘要 :
The development of Goertler vortices with pre-set wavelength of 15 mm has been visualized in the boundary-layer on a concave surface of 2.0 m radius of curvature at a free-stream velocity of 3.0 m/s. The wavelength of vortices was...
展开
The development of Goertler vortices with pre-set wavelength of 15 mm has been visualized in the boundary-layer on a concave surface of 2.0 m radius of curvature at a free-stream velocity of 3.0 m/s. The wavelength of vortices was pre-set by vertical wires of 0.2 mm diameter located 10 mm upstream of the concave surface leading edge. The velocity contours in the cross-sectional planes at several stream wise locations show the growth and breakdown of the vortices. Three different regions can be identified based on different growth rate of the vortices. The occurrence of a secondary instability mode is indicated by the formation of a small horseshoe eddies generated between the two neighboring vortices traveling streamwise, to form mushroom-like structures as a consequence of the non-linear growth of the Gortler vortices.
收起
原文获取